How to Apply the Kirby Glove to Your Club
The Kirby Glove is simple to put over the grip of your club.
1). Remove the black strip and allow the glove to unwind.
2). Remove the plastic wrap from the protected side which is the outer side of the glove.
3). Remove the white strip from the sticky inside of the glove.
4). Start from the top of the grip (about a quarter of an inch from the end) with the small end of the wrap and slowly wrap straight around to allow the glove to stick to the grip. While doing so, slowly rotate the grip while pulling slightly on the glove. Gradually spiral down the grip, overlapping on the embossed edges. Don't allow wrinkles to appear as you wrap. Smooth these out as you spiral down the grip. Use your thumb to insure the glove is snug. Pull as you wrap, but not too tight.
5). Wrap to the metal just below the grip and cut as necessary at an angle - not straight across.
6). Apply the black tape strip neatly around the metal, covering the bottom of the glove.
The Kirby Glove should remain neat and comfortable.
